Bathtub Grips

The bathroom is one important part of a house where family members use for personal necessities. Children, adults and the elderly use it everyday. With that, keeping your bathroom highly comfortable and safe is one considerable step to take. Fortunately, there are a lot of bathroom accessories you can purchase and install today to elevate the level of comfort and safety in your bathroom. One of the most valued is the bathroom tub grips.

The bathtub grips, as they are commonly known, are simply one type of support that works to assist every individual in raising and lowering himself while bathing in the tub. They are designed and made available for use primarily for the fact that people, especially the elderly, often find it hard for them to stand up or lower themselves into the bathtub. There are even some who get injured in climbing in and out of the slippery tubs. So to at least lower the possibility of injuries and at the same time to increase the level of safety inside the bathroom, bathtub grips should be installed.

The installation of bathtub grips is not complicated at all. It can be done easily and quickly if and only if the right tools and materials are provided. However, it is important to note that installing the grip requires a bit of knowledge and skill. Putting it improperly anywhere where it should be placed can only create further accidents. So before making any of the installation moves, see to it that you know exactly what you are doing.

Below are the basics of bathtub grips installation. Note that the installation may vary depending on the variety of grip available. As you may know, there are some grips designed to be installed on the wall, while others are fitted directly into the sides of the bathtub. So the installation presented below is perfect for wall-mounted bathtub grips.

Here Are The Steps

First and foremost, you’ll need to find the studs on the wall where you can create a hole. Finding the studs can be done easily by making a tap on the wall using a material they call as stud finder. Once the stud is found, get a tape measure to locate the center points. The center points are needed primarily for mounting the brackets. Don’t forget to check and double check the dimensions you’ve create, as well as the marked locations. Proceed by drilling a pilot hole into the wall right at the center points. Then, take a saw designed for creating a carbide-tipped hole to make that tiny spot larger. You can use the first pilot hole as your guide. When the hole is created, wipe the wall to free it from dust.

In order to mount the brackets of your bathtub grips, peel first the backing paper off from the bracket’s gasket and then allow the bracket to be slipped into the hole. To create the right installation, follow whatever is directed by the manufacturer. When the bracket is placed, take a screwdriver to release the prongs on the bracket and then tighten the screw to secure the entire bracket. Do the same thing with the second bracket of your grip. And, to complete the step, snatch the so-called escutcheon caps into the area right above the grip’s plates.

That’s simply it! Whatever type of bathtub grips you’ve purchased in store, make sure to follow the installation instructions provided by the manufacturers themselves. This is the most important thing you can do to ensure safety in your bathroom. And, to further elevate the level of comfort in your room, get a dual tub grip which allows you to stand and lower yourself in the tub in both hands.